If you have a pool in your home, you will want to make sure that it is clean and healthy at all times to prevent creating illnesses for you and your family. Always keep your pool in good condition because it can easily get dirty and contaminated. After all, it is out in the open.
It might sound like taking care of your pool is a lot of work, but when you know what to do, you’ll see that it’s not too difficult. Here are a few things you could do to help ensure your swimming pool is clean and healthy.
1. Rake and Vacuum
Table of Contents
If there are trees where your swimming pool is, then you will need to rake and vacuum the area. You can use a net or rake to remove all the dirt and debris that may have gotten into the pool. Professionals also can be hired if you do not have time to attend to your pool.
Clark Rubber has all the tools to remove waste, like leaves, twigs, and branches, if you choose to do the job yourself.
Invest in a scoop with a telescopic pole, an extra broad net, and a strong, lightweight design. This makes it simpler to get to every part of your pool. Meanwhile, use a pool vacuum to remove leaves, dirt, and other objects falling to the pool’s bottom.
2. Always Check Your Pool’s pH Level
The pH level determines how acidic the swimming pool water is. To maximize sanitation, a pool’s pH level should be as low as possible. Nevertheless, the pH level must still be safe for the skin, and you do not want to cause skin problems for the people that use your pool.
Swimming pool water should have a pH between 7.2 and 7.6. Water is neutral at a value of 7.0. At higher and lower values, it is basic and acidic, respectively.
With the use of test strips, you may fairly easily determine the pH level of your swimming pool. Whether the values are accurate is shown by the colors on this strip.
If you see that the pH level is excessively high, this suggests that lime deposits and algae growth may take place. A high pH value is also bad for the skin and eyes. The pH value will then need to be lowered by adding pH minus.
3. Clean Out the Filter
Even if the chemical levels are adequate, a dirty filter can significantly impact water circulation and cause a green or hazy pool.
Millions of minute particles attach to the filter as water flows through it, and this buildup can cause the pump to be slow and ineffective. Remember that filters come in various forms, each with a specific cleaning procedure.
4. Measure and Use Chlorine With Caution
Chlorine pills are frequently required to maintain the cleanliness and clarity of your pool. However, you should use them cautiously and pay close attention to the usage instructions. Your health could be harmed by too much chlorine.
To ensure an adequate chlorine level, you must constantly measure carefully while adding chlorine. A liter of water typically contains between 1 and 2 ppm of chlorine. The chlorine concentration may be raised to 3 ppm/liter if the pool has algae. Test strips can be used to measure this as well.
Chlorine in excess can be detrimental. The mucous membranes and eyes are irritated by the scent of this chlorine. Because too much chlorine might have unpleasant side effects, use caution. Therefore, always abide by the instructions provided with the chlorine products or get professional help.
Keep Your Pool Healthy and Clean
Following these few tips provided will help ensure that your pool is in good condition always. Additionally, it’s important to have your pool routinely inspected by a pool leak detection service to avoid costly repairs. Pool leaks can come out of nowhere and cause expensive damage. Lastly, always keep the pool covered when you know you may not be able to use it for a long time.
A healthy pool is also a healthy you.
No Comments